Total Racing Products PnP Exhaust Backpressure Kit - 2009+ 370Z, G37, GTR

AdminTuning is proud to announce a fully plug & play solution to adding an exhaust backpressure (also called EMAP or drive pressure) input to your ECUTEK-tuned build. Powered by a custom-spec Total Racing Products O2 Hijack Module, this kit allows you to monitor the efficiency of your turbo, turbine housing(s) and exhaust manifolds by measuring the exhaust backpressure it is generating. This is a critical data point when chasing high horsepower numbers as well as mitigating costly damage such as blown head gaskets.

Retuning on ECUTEK is required to enable inputs and setup the channels correctly.

Welding/fabrication is required to install the backpressure coil into your exhaust.

This kit is comprised of the highest quality materials including TXL wire with XLPE insulation which is heat, flame, gasoline and acid resistant along with motorsport grade connectors, a motorsport grade 10-bar pressure sensor, and a fully weatherproofed voltage management unit.

Each kit includes the following hardware:

TRP voltage management unit, compatible with most 5 volt sensors
TRP plug & play wiring harness
AEM Exhaust Backpressure Installation Kit with TRP 10-bar pressure sensor
TRP adapter harness for 2014+ Nissan VQ37 vehicles where applicable

Combining this with our other monitoring kits would allow up to four total inputs you could use on the OEM VQ37 ECU, allowing maximum tuning and datalogging flexibility!